Default Setting (System Menu)
OPERATION GUIDE 8-73
8
6 Press the OK key. This displays the density
selection screen for the mode selected in step 5.
The screen shown is the one when [Manual] is
selected.
7 Press the U or V key to select the density from [-3
Lighter] to [+3 Darker].
8 Press the OK key. Completed. is displayed and the
screen returns to the Send/USB Density menu.
Correct. Bk Line
Correct fine black lines (black streaks caused by contamination), which may appear on the copies, when the
document processor used.
The table below shows the available settings.
NOTE: Using Correcting Fine Black Line can impair reproduction of fine characters. It is recommended to
keep the default ([Off]).
Use the procedure below to specify the setting for correcting fine black lines.
Item Description
Off No correction performed.
On(Low) Correction performed. The reproduction of the image becomes lower when using
Off.
On(High) Correction performed. Select this item if black streak remains after using On (Low).
The reproduction of the image becomes lower when using On (Low).
To Next Page
Loading...
