Kyocera FS-1028MFP

Copying Functions
OPERATION GUIDE 4-13
4
Types of Page Boundary Lines
The following types of the boundary lines are available.
The procedure for using Combine mode copying is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press the Function Menu key. Function Menu
appears.
4 Press the U or V key to select [Combine].
5 Press the OK key. Combine appears.
6 Press the U or V key to select [2 in1] or [4 in 1].
7 Press [Detail] (the Right Select key).
8 Press the U or V key to select the desired layout
and then press the OK key.
None DottedSolid Positioning
Mark
Function Menu: a b
*********************
2 Collate T
3
Duplex T
[ Exit ]
1 Paper Selection g
Combine: a b
*********************
2 2 in 1
3 4 in 1
[ Detail ]
1 *Off
2 in 1 Layout: a b
*********************
2 e R to L
1 * g L to R f T to B