Kyocera FS-1028MFP - Page 281

Default Setting (System Menu)
OPERATION GUIDE 8-89
8
2 Press the OK key. The Adjust/Maint. menu
appears.
3 Press the U or V key to select [Correct. Bk Line].
4 Press the OK key. Correct. Bk Line appears.
5 Press the U or V key to select [Off], [On(Low)] or
[On(High)].
6 Press the OK key. Completed. is displayed and the
screen returns to the Adjust/Maint. menu.
New Developer
When the printing is too light or incomplete, even though there is enough toner, refresh the developer.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [Adjust/Maint.].
2 Press the OK key. The Adjust/Maint. menu
appears.
3 Press the U or V key to select [Service Setting].
4 Press the OK key. The Service Setting menu
appears.
Adjust/Maint.: a b
*********************
2 Send/Box Density
3 Correct. Bk Line
[ Exit ]
1 Copy Denst. Adj.
Correct. Bk Line: a b
*********************
2 On(Low)
3 On(High)
1 *Off
Sys. Menu/Count.: a b
; Document Box
< Edit Destination
*********************
[ Exit ]
= Adjust/Maint.
Adjust/Maint.: a b
*********************
2 Send/Box Density
3 Correct. Bk Line
[ Exit ]
1 Copy Denst. Adj.
Service Setting: a b
*********************
2 Network Status
3 New Developer
[ Exit ]
1 Service Status