Kyocera FS-1028MFP

Default Setting (System Menu)
OPERATION GUIDE 8-129
8
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the U or V key to select [TCP/IP Settings].
6 Press the OK key. The TCP/IP Settings menu
appears.
7 Press the U or V key to select [IPv6 Setting].
8 Press the OK key. IPv6 Setting appears.
9 Press the U or V key to select [On] or [Off].
10 Press the OK key. Completed. is displayed and the
screen returns to the TCP/IP Settings menu.
NetWare Setup
Select the NetWare network connection. After that, select frame types for NetWare network from Auto,
Ethernet-II, 802.3, 802.2, or SNAP. The default settings is "Off".
Use the procedure below to setup the NetWare setting.
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 NetWare
3 AppleTalk
[ Exit ]
1 TCP/IP Settings
TCP/IP Settings: a b
*********************
2 IPv4 Setting
3 IPv6 Setting
[ Exit ]
1 TCP/IP
IPv6 Setting: a b
*********************
2 On
[ Exit ]
1 *Off