Kyocera FS-1028MFP

Default Setting (System Menu)
OPERATION GUIDE 8-131
8
Ether-II
802.2
SNAP
8 Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
For detailed information on restarting the system,
refer to Restarting the System on page 8-126.
AppleTalk Setup
Select the Apple Talk network connection.
Refer to AppleTalk Setup on page 2-20 about the procedures.
WSD Scan Setup
Select whether or not to use WSD Scan. The default setting is On.
Use the procedure below to setup the WSD-SCAN setting. The machine must be restarted after the setting is
changed.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and press the OK key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting