Kyocera FS-1028MFP

Basic Operation
OPERATION GUIDE 3-15
3
Two-sided to Two-sided
Produces two-sided copies from two-sided originals.
The optional document processor is required.
NOTE: The paper sizes supported in Two-sided to
Two-sided are Legal, Letter, Oficio II, Executive, A4,
B5, A5 and Folio.
The procedure for using two-sided/duplex copying is explained below.
1 Press the Function Menu key. Function Menu
appears.
2 Press the U or V key to select [Duplex].
3 Press the OK key. Duplex appears.
4 Press the U or V key to select the desired duplex
copying mode.
NOTE: [2-sided>>1-sided] and [2-sided>>2-sided] are
shown only when the optional document processor
(DP-110) is installed.
If you select [1-sided>>2-sided], press [Detail] (the
Right Select key) and you can select the binding
edge of the finished copies and the original setting
orientation.
After pressing the OK key, select the binding edge
of the finished copies and the original setting
orientation.
Original Copy
5
3
4
1
2
5
3
4
1
2
Function Menu: a b
*********************
2 Collate T
3
Duplex T
[ Exit ]
1 Paper Selection g
Duplex: a b
*********************
2 1-sided>>2-sided
3 2-sided>>1-sied
1 *1-sided>>1-sided
Finish. Binding: a b
*********************
2 p Top
1 * o Left/Right
Orig.Orientation: a b
*********************
2 d Top Edge left
1 * c Top Edge Top