Kyocera TASKalfa 7002i - (4-2) Detaching and reattaching the developer drive motor

2WA/2NJ/2RK
4-124
(4-2) Detaching and reattaching the developer drive motor
Procedures
1. Remove the rear right cover, rear left
cover and rear lower cover. (Refer 1-4-
72)
2. Disconnect the connector (a).
3. Remove two screws (b)(M4x8) and
remove the developer drive unit (c).
4. Check or replace the developer drive
unit (c) and then reattach the parts in
the original position.
Figure 4-186
14j0604
b
a
c