EasyManuals Logo

Kyocera TASKALFA FS-1100 Command Reference

Kyocera TASKALFA FS-1100
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
PRESCRIBE Command Reference
80
DRP — Draw to Relative Position
Format
DRP x-coordinate, y-coordinate, ...;
Parameter
x-coordinate/y-coordinate:
coordinates as measured from the current cursor position
Function
The DRP command draws a line from the current cursor position to a specified relative
position. The thickness of the line is designated by the SPD (set pen diameter) command.
The coordinates and line thickness are measured by the value designated by the UNIT
command.
Multiple pairs of coordinates may be specified. The printing system then draws a
connected series of line segments, proceeding from one point to the next. For example,
DRP 1, 2, 3, 4; is equivalent to DRP 1, 2; DRP 3, 4;. The coordinates may
be positive or negative.
The DRP command is ignored in the path mode graphics. To add a line segment to a
path, use the PDRP (in Path, Draw to Relative Position) command.
File
!R! RES;
UNIT C; SPD .3;
CMNT Cube;
MZP 5, 10;
DRP 4, 0, 2, -2, 0, -4, -4, 0, -2, 2, 0, 4;
MRP 4, 0;
DRP 0, -4, -4, 0, 4, 0, 2, -2;
PAGE;
EXIT;

Table of Contents

Other manuals for Kyocera TASKALFA FS-1100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera TASKALFA FS-1100 and is the answer not in the manual?

Kyocera TASKALFA FS-1100 Specifications

General IconGeneral
TechnologyLaser
Maximum resolution1200 x 1200 DPI
Standard output capacity250 sheets
Duplex PrintingYes
Paper size (tray 1)A4
Print media typesPlain paper, Recycled paper
Standard interfacesUSB 2.0
Product colourWhite
FunctionsPrint
Copy Resolution600 x 600 dpi
Scan Resolution600 x 600 dpi
Operating System CompatibilityWindows

Related product manuals