KARA_SRM_EN_1-0
w w w . l - a c o u s t i c s . c o m
1
11
1
1
11
1 SAFETY WARNINGS
SAFETY WARNINGSSAFETY WARNINGS
SAFETY WARNINGS
All information hereafter detailed applies for the L-ACOUSTICS
®
KARA-MINIBU rigging structure, KARA-
MINIBUEX extension bars, KARA-ANGARMEX angle arm extensions, or KARA-PULLBACK rigging accessory
designated in this section as the product.
1.1 Symbol description
Throughout this manual the potential risks are indicated by the following symbols:
The WARNING symbol indicates a potential risk of physical harm to the user or people within close
proximity to the product.
In addition, the product may also be damaged.
The CAUTION symbol notifies the user about information to prevent possible product damage.
The IMPORTANT symbol is a notification of an important recommendation of use.
1.2 Important safety instructions
1. Read this manual
2. Heed all safety warnings
3. Follow all instructions
4. The user should never incorporate equipment or accessories not approved by L-ACOUSTICS
®
5. Personnel qualification
Installation and set-up should only be carried out by qualified personnel that are familiar with the rigging
techniques and safety recommendations outlined in this manual. It is recommended to attend the training
courses offered by L-ACOUSTICS
®
before proceeding with the loudspeaker assembling procedure.
6. Personnel health and safety
During installation and set-up personnel should wear protective headgear and footwear at all times. Under
no circumstances personnel should climb on the loudspeaker assembly.
7. System parts and rigging inspection
All system components must be inspected before use in order to detect any possible defects.
Please refer to the Care and Maintenance section of this manual as well as any other manuals pertaining
to the system for a detailed description of the inspection procedure.
Any part showing any sign of defect must immediately be put aside and withdrawn from use to be inspected
by qualified service personnel.
8. Additional rigging equipment
L-ACOUSTICS
®
is not responsible for any rigging equipment and accessories provided by third party
manufacturers.
It is the user’s responsibility to verify that the Working Load Limit (WLL) of all additional hardware rigging
accessories is greater than the total weight of the loudspeaker assembly in use.
To Next Page
Loading...
Need help?
General
