L-Acoustics L2 - System Components; Loudspeaker Enclosures

System components
System components
Loudspeaker enclosures
L2 16-channel active progressive curvature WST 10° enclosure: 4 × 12" LC + 8 × 10" LF + 8 × 3"
HF
L2D 16-channel active progressive curvature WST 60° enclosure: 4 × 12" LC + 8 × 10" LF + 8 × 3"
HF
KS28 Flyable subwoofer 2 × 18"
Powering and driving system
LA7.16 Amplified controller 16 × 1300 W / 8 ohms
LA7.16i Install-specific amplified controller 16 × 1300 W / 8 ohms
Refer to the LA7.16 / LA7.16i owner's manual for operating instructions.
Racks
LA-RAK III Touring rack containing three LA7.16, one LA-POWER II for power distribution, one LA-
PANEL III for audio signal distribution, and two LS10 for AVB distribution
Cases
L-CASE II 2U electronics transport and protection case
Cables
SC32 cables 16-channel loudspeaker cables for touring application (37-point female connector to 37-point
male connector, 32 points used, 1.5 mm² gauge)
Come in different lengths: SC32-5 (5 m / 16.4 ft), SC32-10 (10 m / 32.8 ft), SC32-25 (25 m /
82 ft), SC32-50 (50 m / 164 ft)
SC32P 16-channel loudspeaker cable extension adaptor (37-point female connector to 37-point male
connector, 32 points used, without locking rings, 1.5 mm² gauge)
Length: 0.3 m / 1 ft
SC32 BE cables 16-channel loudspeaker cable for fixed installation (37-point female connector to 32 bare end
cables for connection to a 16-channel amplified controller, 1.5 mm² gauge)
Come in different lengths: SC32-5 BE (5 m / 16.4 ft), SC32-10 BE (10 m / 32.8 ft)
SC32ROLL-500 BE 16-channel loudspeaker cable for custom cable creation (32 bare end cable, 1.5 mm² gauge)
Length: 500 m / 1640 ft (on a spool)
Information about the connection of the enclosures to the LA amplified controllers is given in this
document.
Refer to the LA7.16 / LA7.16i owner's manual for detailed instructions about the whole cabling scheme,
including modulation cables and network.
Rigging elements
L2-BUMP Flying frame for L2 and L2D (incl. 1 extension sling + 1 laser adapter)
L2-BAR Extension bar for L2-BUMP
L2-RIGBAR Rigging bar and pullback for L2 and L2D
LA-RAKMOUNT Mounting cradles for racks, including screws
L2 owner's manual (EN) version 5.0 11