Rigging procedures
Adjusting L2D-CHARIOT site angle with K2-JACK
Type of deployment stacking
Rigging accessories K2-JACK
L2D-CHARIOT
Min number of operators 2
Tipping hazard
Always install K2-JACK before setting the L2D-CHARIOT site angle.
See Attaching K2-JACK stabilizers to L2-CHARIOT/L2D-CHARIOT (p.129).
Procedure
Do not remove the ball-locking pins securing L2D to L2D-CHARIOT.
1. Remove the bottom ball-locking pin on each side.
134 L2 owner's manual (EN) version 5.0
To Next Page