Using the data contained in your destination microplate definition, the protocol definition, and the source microplate
survey just performed, droplets are ejected from each specified source microplate well into the corresponding destination
microplate well. A progress bar keeps you informed of the liquid transfer in progress.
You can abort the liquid transfer process by clicking the Abort button.
5. When the liquid transfer is complete, click the Next button.
The destination plate gripper stage extends outside of the Echo Liquid Handler and reverts the plate to its upright position.
6. Remove the destination microplate and click the Next button.
The destination plate gripper stage retracts into the Echo Liquid Handler and the source plate gripper stage extends
outside of the Echo Liquid Handler.
7. Remove the source microplate and click the Done button.
The source plate gripper stage retracts into the Echo Liquid Handler.
Echo Liquid Handler Software CHAPTER 5 | Software
108
To Next Page
Loading...
