Lagler Flip - Connecting the Power Cable and Safety

FLIP
®
01.01.2019
English / Englisch
Fig. 6 Secure the dust bag using the quick-release
fasteners.
Fig. 7 Connect the motor cable to the extension cable.
6 Attach the dust bag to the locating flange using the two
quick-release fasteners (fig. 6).
4.2 CONNECTING THE POWER CABLE
WARNING!
RISK OF DEATH from electrical shock:
• Never connect the machine on hazardous electrical
power sources such as electrical installations that are too
weak, not fuse protected or without electrical grounding!
Only use safety sockets!
• To protect yourself and the machine against faults in the
mains supply use a safety switch PRCD (for German mains
supply part number in Section 11, Spare parts FLIP
®
)!
• Observe the applicable regulations and legal requirements
in your country!
RISK OF FIRE from the overheating of the cables:
• Only cables with two wires and wire cross-section of at
least 1.5 mm² (0.0023 sq.in.) may be used as motor cables!
• Only cables with two or three wires and wire cross-
section of at least 1.5 mm² (0.0023 sq.in.) may be used as
power cables!
• The maximum cable length in order to connect the
machine to the mains supply must not exceed 20 m (790”)!
1 Insert the plug of the motor cable in the coupler of the
extension cable (fig. 7).
2 Attach the extension cable coupler to the dust bag using the
Velcro loop (fig. 8).
3 Insert the extension cable into a sufficiently protected power
socket.
COMMISSIONING
Fig. 8 Attach the extension cable coupler to the dust
bag.
4
17