Lagler Flip - 5 Working with the FLIP; General Application Tips for FLIP

FLIP
®
01.01.2019
English / Englisch
WARNING!
RISK OF DEATH from electrical shock:
The machine may never be used for wet processing operations
of any kind!
WORKING WITH THE FLIP
®
5.1 GENERAL APPLICATION TIPS
WARNING!
RISK OF DEATH from electrical shock:
The machine may never be used for wet processing operations
of any kind!
ATTENTION!
• Bear in mind that the FLIP
®
operates at very high cutting
speeds! For this reason, there is a risk of burn marks for
finer grit grades!
• Do not apply excessive pressure to the attachment while
sanding!
Excessive pressure
- significantly worsen the sanding finish by causing deep
scratches or burn marks on the floor,
- could cause the motor to switch off from overheating!
The FLIP
®
is used for the dry sanding of edges, corners and stairs.
The attachment can be changed in a matter of seconds (
Sec-
tion 7.3.1, Removing the V-belt, step 1 to 6 and Section 7.3.2, In-
stalling the V-belt, step 5 to 8).
• The FLIP
®
with short or long attachment is handled with rotary
clockwise movements (fig. 12) during the sanding process!
• The FLIP
®
with corner attachment is handled with
counterclockwise movements (fig. 13) during the sanding
process! Otherwise deep sanding marks might be generated
which could be removed by a very time-consuming procedure
afterwards only!
• Deep sanding marks due to the selection of a too coarse grit
grade can be prevented by starting the first sanding operation
with the finest grit grade possible.
Working with the FLIP
®
Fig. 11 Guide the FLIP
®
with both hands.
NOTE:
For more information free of charge, please
contact: within Germany
- Telephone: 0800 / 52 34 537
- Fax: 0800 / 48 66 353
within the USA
- Telephone: 800-848-6635
or
- Telephone: 0049 - 7135 - 98 90 - 0
- Fax: 0049 - 7135 - 98 90 - 98
- E-mail: info@laegler.com
- Internet: http://www.laegler.com
You will also find important and interesting
application tips in the LÄGLER
®
application
technique manual “Sanding of wooden
floors” (http://www.laegler.com)!
5
Fig. 12 FLIP
®
with short or long attachment:
Rotary clockwise movements!
20