EasyManua.ls Logo

Lagler Flip - Troubleshooting: Intense Vibration and Noise; Troubleshooting: Excessive Dust Creation

Lagler Flip
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FLIP
®
01.01.2019
English / Englisch
CAUSES OF FAULTS
9.4 THE MACHINE VIBRATES INTENSELY AND
RUNS NOISILY
• The sanding medium does not have the proper tension. The
tension must be corrected.
Section 5.2, Replacing the sanding medium
• The sanding medium is damaged or incorrect and must be
replaced.
Section 5.2, Replacing the sanding medium
• The V-belt is dirty, damaged or worn-out and must be
replaced.
Section 7.3, Replacing the V-belt
• A pulley is dirty, damaged or worn-out and must be cleaned
or replaced.
Section 7.4, Replacing the complete sanding plate
Section 7.5, Replacing the motor pulley
• There are clogged materials and deposits in the machine
that must be removed.
Section 7.1, Cleaning and care
9.5 THE MACHINE RUNS BUT CREATES A GREAT
DEAL OF DUST
• The dust bag is more than one third full and must be emptied.
Section 5.3, Emptying the dust bag
• The dust bag is not correctly attached or is damaged and
must be replaced.
Section 4.1, Preparing the machine
• When mounting the attachment, the belt tightening plate was
pinched between the attachment and the fan housing. The
attachment must be properly installed.
Section 7.3.2, Installing the V-belt
• There are clogged materials and deposits in the machine
that must be removed.
Section 7.1, Cleaning and care
• More than one sanding disc is mounted. Only install one
sanding disc.
Section 5.2, Replacing the sanding medium
• The machine setting angle is too steep. The guide rollers
must be properly adjusted.
Section 7.8, Adjusting the guide rollers
9
48

Table of Contents