FLIP
®
01.01.2019
English / Englisch
Fig. 21 Remove the coupler from the Velcro loop on the
dust bag.
5.3 EMPTYING THE DUST BAG
WARNING!
RISK OF FIRE from the formation of sparks while sanding:
• Note the warning on the motor housing (fig. 19)!
• The dust bag must always be removed from the machine
directly after sanding and emptied into a waste bag with
the emptying fixture! Dispose of these waste bags in a
non-combustible container!
Cover this container with a non-combustible cover (fig. 32)
and be certain to store it outdoors in non-combustible
environment!
• Always transport and store used dust bags in closed and
non-combustible containers!
HEALTH RISK caused by dust:
In order to ensure that the dust values in the air do not exceed
the prescribed threshold levels, please note:
• The dust bag must be emptied when it is one-third full at
the very latest in order to prevent a deterioration of the
suction performance due to the lack of filtering surface
area! The horizontal line on the outside of the dust bag
marks the maximum fill level (fig. 20)!
• Do not work with an overfilled dust bag!
• Do not wash, patch or repair the dust bag in any other
manner!
• Damaged dust bags must be replaced with new ones!
• When emptying the dust bag, wearing a respiratory
protective mask (at least filter class P2) is recommended!
In order to empty the dust bag in a manner as free from dust
as possible, an emptying fixture, a waste bag and cable tie are
included with the FLIP
®
.
Proceed as follows to empty the dust bag:
1 Switch off the machine and pull the power plug out of the
socket!
2 Remove the extension cable coupler from the Velcro loop on
the dust bag (fig. 21).
WORKING WITH THE FLIP
®
5
Fig. 19 Note the warning on the motor housing!
Fig. 20 The horizontal line marks the maximum fill level
of the dust bag.
24
To Next Page
Loading...
