FLIP
®
01.01.2019
English / Englisch
This section shows you how to remedy possible malfunctions. If
none of the measures listed here are successful, please contact
our service department, your retailer or your importer.
9.1 THE MACHINE DOES NOT RUN OR HAS
SWITCHED OFF AUTOMATICALLY
• The machine is not connected to the electrical network.
Check the following items:
- Is the motor cable connected to the extension cable?
- Is the extension cable inserted into the power socket?
• The power socket is not properly connected. This error must
be corrected by an expert.
• The electrical safety device of the electrical network
interrupted the electrical circuit, e.g. because
- too many electricity consumers are connected to the same
electrical circuit,
- improper electrical installation.
The causes for the error must be repaired by an expert.
• The electrical network is not providing sufficient voltage
(undervoltage). Use a transformer if necessary (e.g. LÄGLER
®
part number 708.00.00.100 for 230 V).
• The temperature switch in the motor has switched off the
machine because
- the power cables have a total length of more than 20 m
(790”),
- the power cables have wire cross-sections which are
smaller than 1.5 mm² (0.0023 sq.in.),
- or too much pressure was applied to the attachment while
sanding.
The motor must cool off and the causes for the problems
named above must be remedied.
• An electrical component of the machine (e.g. cable, switch)
is defective and must be inspected by a qualified electrician
and replaced if necessary.
• The wear limit of the carbon brushes has been reached. The
carbon brushes must be replaced.
Section 7.6, Replacing the carbon brushes
Use only original FLIP
®
carbon brushes with safety contacts
(part number in section 11, Spare parts FLIP
®
)!
Causes of faults
CAUSES OF FAULTS
WARNING!
RISK OF DEATH from electrical shock:
Work on the electrical equipment is to
be conducted exclusively by a qualified
electrician (circuit diagram in Section 10)!
The machine must be switched off and
the power plug removed from the socket
during this work!
RISK OF INJURY due to unsuitable parts:
Make sure that only original LÄGLER
®
spare parts and original LÄGLER
®
acces-
sories are used!
9
46
To Next Page
Loading...
