Lagler Flip - Replacing Wheels and Guide Rollers

FLIP
®
01.01.2019
English / Englisch
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7.9 REPLACING THE WHEELS AND THE GUIDE
ROLLERS
ATTENTION!
• Blocked wheels or guide rollers restrict the mobility of
the machine and leave marks on the floor! These parts
must be replaced!
• Always replace both wheels or guide rollers!
7.9.1 REPLACING THE WHEELS
Use only original LÄGLER
®
wheels (part number in Section 11,
Spare parts FLIP
®
)!
The wheels must be replaced when the contact surfaces are
worn-out or damaged or the wheels can only be turned by applying
additional force.
1 Switch off the machine and pull the power plug out of the
socket!
2 Remove the screw with the two washers and the nut from
the wheel fork (fig. 68, 1).
3 Remove the wheel from the wheel fork (fig. 68, 2).
4 Install the new wheel in the reverse order.
7.9.2 REPLACING THE GUIDE ROLLERS
Use only original LÄGLER
®
guide rollers (part number in Section 11,
Spare parts FLIP
®
)!
The guide rollers must be replaced when the wheel forks only
rotate around the vertical guide roller axes with increased force!
1 Switch off the machine and pull the power plug out of the
socket!
2 Remove the locknut of the guide roller (fig. 56).
7
Fig. 68 Remove the screw, the two washers and the nut (1)
and remove the wheel from the wheel fork (2).
41