Lagler Flip - 6 Transport and Storage; Transport and Storage Procedures

FLIP
®
01.01.2019
English / Englisch
WARNING!
RISK OF DEATH and RISK OF PROPERTY DAMAGE from
unsecured load:
When transported in a motor vehicle or the like, the machines
and all parts must be secured against sliding!
RISK OF FIRE from spontaneous combustion or from the
formation of sparks while sanding:
• Oil or wax can lead to spontaneous combustion! There-
fore, the machine must always be cleaned carefully
directly after sanding!
• Always transport and store the cleaned machine without
dust bag! Store used dust bags in closed and non-
combustible containers!
If the machine must be stored for a longer period of time, take the
measures necessary to ensure dry and frost-free storage with
minimum temperature fluctuations.
In order for the FLIP
®
to need less space for transport or storage,
proceed as follows:
1 Pull out the stop bolt in the fan house (fig. 33, 1).
2 At the same time, turn the pipe socket until the dust bag is
positioned over the attachment (fig. 33, 2) and the stop bolt
noticeably snaps into place in the pipe socket when released
(fig. 33, 3).
CAUTION!
RISK OF INJURY and RISK OF PROPERTY DAMAGE:
The stop bolt must always snap into place in the pipe socket!
3 You can easily carry the machine using the pipe socket
(fig. 34).
Transport and storage
TRANSPORT AND STORAGE
Fig. 34 Carry the FLIP
®
by the pipe socket.
Fig. 33 Pull out the stop bolt (1) and simultaneously turn
the pipe socket (2). Then release the stop bolt (3).
It must snap into place in the pipe socket!
6
NOTE!
You can use parts of the transport packing
to transport or store the machine!
27