Lagler Flip - Page 39

FLIP
®
01.01.2019
English / Englisch
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7 Conduct a trial sanding operation and check the sanding
results.
8 If the machine sands centrically (fig. 59), the guide rollers
are properly adjusted.
9 If the machine sands too much to the right (fig. 60) or to the
left (fig. 62), the guide rollers are not adjusted to the same
height (fig. 61 and fig. 63)!
10 Adjust both guide rollers to the same height ( steps 1 to 6)
and repeat the trial sanding operation.
7
Fig. 62 Improper adjustment of the guide rollers:
The sanding zone of the machine is too much to
the left.
Fig. 60 Improper adjustment of the guide rollers:
The sanding zone of the machine is too much to
the right.
Fig. 59 Proper adjustment of the guide rollers:
The machine sands centrically.
Fig. 61 The sanding zone of the machine is too much to
the right:
The left guide roller is lifting the machine too
much.
Fig. 63 The sanding zone of the machine is too much to
the left:
The right guide roller is lifting the machine too
much.
39