Lantronix EDS4100

A: Configuration Using Telnet or Serial Port
EDS4100 4 Port Device Server User Guide 140
Configure Menu
Command
Description
snmp-server community
<string> ro
Sets the read-only community within the SNMP server.
<string> = name of the read-only community that is to be
set.
snmp-server community
<string> rw
Sets the read-write community within the SNMP server.
<string> = name of the read-write community that is to be
set.
snmp-server contact
<string>
Sets the SNMP system contact information.
<string> = system contact information.
snmp-server description
<string>
Enter a description for SNMP server.
<string> = description of server.
snmp-server enable
Enables the SNMP server.
snmp-server enable
traps
Enables traps on the SNMP server.
snmp-server host <ip
address>
Sets the primary SNMP trap host.
<ip address> = IP address of host running the SNMP
trap.
snmp-server host <ip
address1> <ip address2>
Sets the primary and secondary SNMP trap hosts.
<ip address1> = IP address of primary host running the
SNMP trap.
<ip address2> = IP address of secondary host running
the SNMP trap.
snmp-server location
<string>
Sets the SNMP system location.
<string> = SNMP system location.
snmp-server name
<string>
Sets the SNMP system name.
<string> = SNMP system name.
write
Stores and applies the current configuration into
permanent memory.