15: Security Settings
PremierWave® XC HSPA+ Intelligent Gateway User Guide 108
Trusted Authorities
One or more authority certificates are needed to verify a peer's identity. These certificates do not
require a private key.
Using Web Manager
To upload an Authority Certificate, click SSL in the menu and select Trusted Authorities.
Using the CLI
To enter the SSL command level: enable -> ssl
To enter the Trusted Authorities command level: enable -> ssl -> trusted
authorities
Using XML
Include in your file:
<configgroup name=”ssl”>
and <configitem name=”trusted authority” instance =”1”>
and <configitem name=”intermediate authority” instance=”1”>
Table 15-9 Trusted Authority Settings
Trusted Authorities
Settings
Description
Authority Click Choose File to browse to and select the SSL authority certificate.
RSA or DSA certificates are allowed.
The format of the authority certificate can be PEM or PKCS7. PEM files
must start with “-----BEGIN CERTIFICATE-----” and end with “---
--END CERTIFICATE-----”. Some Certificate Authorities add
comments before and/or after these lines. Those need to be deleted
before upload.
Authority Certificate
Type
This field will be automatically updated depending upon extension of the
certificate entered. If the field is NONE i.e., certificate is not supported
then it will not load. If the field is PKCS12, In the Password: field
corresponding PKCS12 password should be entered.
Delete Click the Delete button beside a specific certificate authority to delete it.
Delete All Click the Delete All button to delete all existing certificate authorities.
To Next Page
Loading...
Need help?
General
