6: Network Settings
PremierWave® Intelligent Gateway User Guide 56
To Configure VPN Settings
Using Web Manager
To view or configure VPN information, click VPN in the menu.
Using the CLI
To enter the VPN command level: enable -> config -> vpn
Using XML
Include in your file: <configgroup name = "vpn">
GRE Settings
GRE tunneling is available on the PremierWave XC HSPA+ intelligent gateway, providing more
capabilities than IP-in-IP tunneling. For example, it supports transporting multicast traffic and IPv6
through a GRE tunnel.
Table 6-24 GRE Settings
Unreachable Host Detection
Host Enter the Host to use failover host and ping interval to monitor connectivity
with a host on the remote network.
Ping Interval Indicate the ping interval, in minutes, to use failover host and ping interval to
monitor connectivity with a host on the remote network.
Max Tries Enter the tries for the VPN tunnel is restarted if Max Tries pings to the host
fail.
GRE Settings Description
Name Enter the user-defined name of the GRE tunnel.
State Select to enable and disable GRE tunnel.
IP Address Assign an IP address/mask for the GRE tunnel.
MTU Enter the number of bytes indicating the largest physical packet size that the
network can transmit.
Local Network Select the local network to use the GRE tunnel. Select vpn to use the VPN
network. Select any to use any available interface to remote host.
Remote Host Enter the remote IP address to use for the GRE tunnel.
Remote Network Enter the remote network to use for the GRE tunnel.
VPN Settings Description
To Next Page
Loading...
Need help?
General
