16: Maintenance and Diagnostics Settings
PremierWave® XC HSPA+ Intelligent Gateway User Guide 115
To Ping a Remote Host
Using Web Manager
To ping a Remote Host, click Diagnostics in the menu and select Ping.
Using the CLI
To enter the command level: enable, ping <host> <count> <timeout>
Using XML
Not applicable.
Traceroute
Here you can trace a packet from the PremierWave XC HSPA+ intelligent gateway to an Internet
host, showing how many hops the packet requires to reach the host and how long each hop takes.
If you visit a web site whose pages appear slowly, you can use traceroute to determine where the
longest delays are occurring.
Table 16-9 Traceroute Settings
To Perform a Traceroute
Using Web Manager
To perform a Traceroute, click Diagnostics in the menu and select Traceroute.
Using the CLI
To enter the command level: enable, trace route <host>
Using XML
Not applicable.
Timeout Enter the time, in seconds, for the PremierWave XC intelligent gateway to wait for a
response from the host before timing out. The default is 5 seconds.
Submit (Button) Click the Submit button after entering ping information.
Diagnostics:
Traceroute Settings
Description
Host Enter the IP address or DNS hostname. This address is used to show the path
between it and the PremierWave device when issuing the traceroute command.
Protocol Select the traceroute protocol from the drop-down menu.
Submit (button) Click the Submit button after entering traceroute information.
Diagnostics: Ping
Settings (continued)
Description