6: Network Settings
PremierWave® Intelligent Gateway User Guide 43
Using the CLI
To enter the eth0 QoS command level: enable -> config -> if 1 -> qos
Using XML
Include in your file: <configgroup name="qos" instance="eth0">
Network 1 (eth0) Failover
The PremierWave XC HSPA+ intelligent gateway provides Cellular WAN network failover, in the
form of a "dead remote host reachability" mechanism (essentially a ping against a known host). If
the remote host is determined to be not reachable, the device will failover to the Wi-Ficellular
interface. If the remote host is determined to be reachable, the device will failback to the Ethernet
interface.
Table 6-5 Network 1 (eth0) Failover Settings
To Configure Network 1 Failover Settings
Using Web Manager
To modify Failover settings, click Network on the menu and select Network 1 > Failover >
Configuration.
Using the CLI
To enter the eth0 link command level: enable -> config -> if 1 -> failover
Using XML
Include in your file: <configgroup name="network failover" instance="eth0">
Network 1 (Failover)
Settings
Description
State Click to enable or disable state.
Failover Interface Always select wwan0 in the PremierWave XC HSPA+ intelligent gateway.
Hostname Enter the remote host to test reachability.
Method Select ICMP or TCP based ping.
Timeout Indicate the interval to wait for ping response from remote host.
Interval Indicate the interval in which to test reachability
Failover Threshold Indicate the allowed number of failed pings – after which the device will
failover to the cellular interface.
Failback Threshold Indicate the number of successful pings – after which the device will failback
to the Ethernet interface.
To Next Page
Loading...
Need help?
General
