Lantronix PREMIERWAVE XC HSPA+ User Manual

2: Introduction
PremierWave® XC HSPA+ Intelligent Gateway User Guide 20
IP Address
Every device connected to an IP network must have a unique IPv4 address. This address
references the specific unit.
Port Numbers
Every TCP connection and every UDP datagram is defined by a destination and source IP
address, and a destination and source port number. For example, a Telnet server commonly uses
TCP port number 23.
The following is a list of the default server port numbers running on the PremierWave XC HSPA+
intelligent gateway:
 TCP Port 22: SSH Server (Command Mode configuration)
 TCP Port 23: Telnet Server (Command Mode configuration)
 TCP Port 80: HTTP (Web Manager Configuration)
 TCP Port 21: FTP
 UDP Port 30718: LDP (Lantronix Discovery Protocol) port
 TCP/UDP Port 10001: Tunnel 1 (see note below)
 UDP Port 1900 and TCP Port 30179: UPnP
Note: Additional TCP/UDP ports and tunnels will be available, depending on the product
type. The default numbering of each additional TCP/UDP port and corresponding tunnel
will increase sequentially (i.e., TCP/UDP Port 1000X: Tunnel X).
Product Information Label
The product information label on the unit contains the following information about the specific unit:
 Part Number
 International Mobile Equipment Identity
(IMEI) Number
 Serial Number (MAC Address)
 Country of Origin
 Product Revision
 Manufacturing Date Code
Figure 2-1 PremierWave Unit Product Label
Note: The hardware address on the label is
also the product serial number. The hardware
address on the label is the address for the
Ethernet (eth0) interface.
Part Number
Revision
Serial Number
Country of Origin
Data Code
IMEI Text

Lantronix PREMIERWAVE XC HSPA+ Specifications

General

Brand	Lantronix
Model	PREMIERWAVE XC HSPA+
Category	Gateway
Language	English