4 Before starting up
4.1 Installation
Special installation conditions apply to the devices. These installation condi-
tions are specified for the most part in the technical data for the device.
You will find further information on the technical data in
Ä Chapter 11.1 “General and type-specific data” on page 82.
Additional installation conditions are described in the following.
n Irritant vapors may develop, depending on the heat transfer liquid and
operating mode used. Always ensure that the vapors are adequately
extracted.
n Note the electromagnetic compatibility (EMC) requirements of the
device.
n Do not cover the ventilation openings.
You will find further information on the EMC requirements in
Ä Chapter 1.5 “EMC requirements” on page 8.
Operation outdoors for outdoor temperatures below 5 °C
A warning which states the preheating time of the compressor or
that the compressor should be preheated is shown in the display.
The compressor may suer increased wear or material damage if it
is not preheated! You will find further information in Ä “Outdoor
installation” on page 21.
Personnel:
n
Operating personnel
WARNING!
Rolling away or overturning of the device due to incorrect han-
dling
Impact, crushing
Do not tilt the device.
Position the device on an even, non-slip surface with a
sucient load carrying capacity.
Actuate the castor brake when setting up the device.
Do not place heavy parts on the device.
1. Place the devices on a suitable level surface.
The devices can be moved. To do this, release the locking
brakes on the castors by pushing the lever upwards.
2. Lock the castors of the device. Press the lever down with your foot to
lock.
V08
Variocool 23 / 97
To Next Page
Loading...
Need help?
General
