EasyManuals Logo

Lauda Variocool VC 1200 User Manual

Lauda Variocool VC 1200
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
1. Switch to the main menu.
2.
Select the menu item Setup Cooling.
3. Select one of the following options:
n With the [autom.] setting, the cooling unit is switched automati-
cally. When cooling capacity is required, the cooling unit switches
on.
n With [o], the cooling unit always remains switched o.
n With [on], the cooling unit is always switched on, even if no
cooling capacity is required.
4. Press the input button to confirm.
Under certain conditions, lengthy downtimes (several
minutes) of the cooling unit occur in devices without a heater
when in the [autom.] setting.
If the consumer load is extremely low, the cooling unit automatically switches
o as soon as the temperature is 2 K below the set point. On the other hand,
heat input from the pump and consuming unit means that the cooling unit
does not switch on until the set point is exceeded by 2 K.
The outflow temperature always moves ±2 K around the set point in this
so-called two-position control. A tighter control range causes the cooling
unit to switch on and switch o more frequently. This has negative impacts
on the service life of the refrigeration compressor.
A low consumer load can therefore result in the temperature stability of
±0.05 K or ±0.1 K not being achieved. The specified temperature stability is
always achieved if a heater is used.
On devices with a heater and the [autom.] setting, the cooling unit only
switches o if no cooling capacity is required.
6.10 External control
6.10.1 Activating the external control
Personnel:
n
Operating personnel
1.
Select the menu item Control Variable extern Pt100 in the Control
menu.
This option is only available if a Pt100 module for an
external temperature probe has been connected. A Pt100
temperature sensor must be connected to the module.
2. Press the input button to confirm.
Fig. 27: Setting the cooling
Cooling in a device without a heater and in
the [autom.] setting
Cooling in a device with a heater and in the
[autom.] setting
Fig. 28: Activating the external control
V08 Variocool 45 / 97

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lauda Variocool VC 1200 and is the answer not in the manual?

Lauda Variocool VC 1200 Specifications

General IconGeneral
BrandLauda
ModelVariocool VC 1200
CategoryChiller
LanguageEnglish

Related product manuals