2. You can navigate through the list using the up and down arrow keys.
The following information is displayed for each message:
n The relevant module that triggered the message is displayed under
Source .
n Code
is the encoded description of the alarm, warning or error.
n Type specifies whether it is an alarm, warning or error.
n Date
and Time display the exact time the message was issued.
You will find a list of the possible alarms, warnings and errors
in Ä “Procedure in the event of alarms” on page 73.
6.16.3 Retrieving device data
1. Select the Device data
menu item in the Device status menu.
Various current parameters are displayed.
6.16.4 Retrieving the software version
Amongst other things, the respective software versions are needed for
service cases.
Personnel:
n
Operating personnel
1. Select the SW version menu item in the Device status menu.
The respective software versions are displayed depending on the
device type and the connected modules.
6.16.5 Displaying device type
The device type is shown directly at the menu item Type in the Device status
menu.
Fig. 54: Error store
Fig. 55: Device data
V08Variocool60 / 97
To Next Page
Loading...
Need help?
General
