Leader Scan - Sensor Battery Charging

17
2.2.5 Sensor battery charging
1. Connect the CA plug
of the VL-VPC1 IDX charger
to the 100-240V socket.
2. Place the ENDURA CUE D75
battery in the charger.
Battery charged
The red LED turns
red.
The charging starts
automatically if the battery
is not fully charged.
The red LED
starts to flash.
3. When charging
is complete:
The red LED turns
red.
The approximate charge time
for 1 completely flat battery is
4.5 hours.
3. Once fully charged, remove
the battery from the charger
base using the push button on
the side.