6.3 Cleaning and Drying
•
Blow dus
t off lenses and prisms.
•
Never touch the glass with your fingers.
•
Use only a clean, soft, lint-free cloth for cleaning. If necessary, moisten the
cloth with water or pure alcohol. Do not use other liquids; these may
attack the polymer components.
Prisms that are cooler than the ambient temperature tend to fog. It is not
enoug
h simply to wipe them. Keep them for some time inside your jacket or in
the vehicle to allow them to adjust to the ambient temperature.
Dry the product, the transport container, the foam inserts and the accessories
a
t a temperature not greater than 40°C /104°F and clean them. Remove the
battery cover and dry the battery compartment. Do not repack until everything
is completely dry. Always close the transport container when using in the field.
Keep plugs clean and dry. Blow away any dirt lodged in the plugs of the con-
nec
ting cables.
6.4 Maintenance
An inspection of the motorisation in motorised instruments must be done in a
Leica G
eosystems authorised service centre. Leica Geosystems recommends an
inspection of the product every 12 months.
For instruments which are in intensive or permanent use, for example tunnel-
ling or monitoring, the recommended inspection cycle may be reduced.
Product and accesso-
ries
Fogging of prisms
Damp products
Cables and plugs
☞
Care and Transport 59
To Next Page
Loading...
