5.4006.8501.0 B
6-4 Maintenance
6.3.2 Clean the Water Inlet Filter
Make sure to reinstall the water inlet filter properly after cleaning to avoid water
damage.
Make sure not to lose the rubber seal (2) that is installed inside the cap.
Preparation
1. Manually drive the machine to a clean and quiet location (see Manually drive the Machine on page 5-
6).
Unexpected cow movement.
Risk of being crushed or trampled.
Block the cow traffic.
2. Remove the upper cover (see Remove or install the Covers on page 5-2).
Clean
Figure 42. Clean the water inlet filter
KEY: 1. Water inlet filter - 2. Filter - 3. Seal - 4. Cap
1. Turn the cap (4) counter clockwise to remove it from the filter housing.
2. Remove the filter (2) from the filter housing.
3. Clean the filter and the cap.
4. Install the filter in the filter housing
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...