5.4006.8501.0 B
5-2 Operating Instructions
It is recommended to use the same password for all smartphone controlled machines on
a farm.
5.4 Remove or install the Covers
Preparation
1. Stop the time path to take the machine out of operation (see Start or Stop the Time Path on page 5-
32).
2. Manually drive the machine to a clean and quiet location (see Manually drive the Machine on page 5-
6).
Removal
Figure 22. Remove or install the covers
KEY: 1. Bolt - 2. Washer - 3. Upper cover - 4. Frame - 5.
Water tank - 6. Lower cover
1. Loosen the bolt (1) on the upper side of the
upper cover (3).
2. Rotate (A) the upper cover (3) towards the front
side of the vehicle to remove the upper cover
from the chassis (4).
3. Only if necessary, remove (B) the lower cover (6)
from the vehicle.
Installation
1. Reinstall the lower cover (6).
2. Put the bracket of the upper cover in the slot at the front side of the of the machine (4).
3. Lower the upper cover (3) at the rear side.
4. Install the bolt of the upper cover (1).
Close-up
1. Manually drive the machine to the charging station (see Manually drive the Machine on page 5-6).
2. Start the time path to put the machine into operation (see Start or Stop the Time Path on page 5-32).
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...