5.4006.8501.0 B
4-8 Description and Operation
The Lely Control app controls and monitors the machine and communicates with the management
software. The Lely Control app is available in the Google play store (Android) and the Apple app store
(iOS).
The user interface of the Lely Control app displays nine buttons that enable the user to give commands
and change values in the machine. The user interface also shows reports and alarms.
The Lely Control app communicates via bluetooth with the software on the ADS 3840 PCB.
The user interface has the following buttons:
•
Execute the command on the display above the applicable soft button.
•
starts or stops an action.
•
Moves the selector up one item or increases a value by one.
•
Moves the selector down one item or decreases a value by one.
•
Opens the selected function or the next menu screen.
•
returns to the previous screen.
•
Reduces the speed of the vehicle.
Acoustic signal
The Lely Control app gives an acoustic signal when:
• The machine is in normal operation.
• Settings are saved.
• The calibration of the gyroscope is finished.
• Backup is finished (create / restore).
• Programming a route.
4.2.2 Charging Station
The machine normally starts and ends at the charging station. The machine recharges itself at the
charging station. The battery charger electrodes are at the front near the bottom of the charging station.
The machine can be left permanently connected to the charging station. This keeps the battery in good
condition. The ADS3840 PCB continuously examines the voltage of the battery. It is not possible to
overcharge the battery.
The charging station has a 20 A electronic battery charger.
The charging station can be installed in the barn in two ways:
• Wall-mounted.
• Floor-mounted.
If it is not possible to install the charging station to the wall, an optional floor column can be supplied.
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...