5.4006.8501.0 B
6-10 Maintenance
Figure 46. Horizontally positioned nozzle
KEY: 1. Nozzle
Close-up
1. Use a suitable lifting or tilting tool to put the machine back onto its wheels.
2. Test the spraying as follows:
1. In the main menu select Test and push
.
2. Select Test sprinkler and push
and check if the nozzle sprays correct.
3. Drive the Machine to the Charging Station (see page 5-6).
4. Start the time path (see Start or Stop the Time Path on page 5-32).
6.3.5 Clean the Ultrasonic Sensor
Inspect the black foam ring on the ultrasonic sensor after cleaning. Replace the foam ring
if it is damaged.
Preparation
1. Manually drive the machine to a clean and quiet location (see Manually drive the Machine on page 5-
6).
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...