5.4006.8501.0 B
Maintenance 6-7
1. Disconnect the filter tubes from the pump (1) (see figure 43 on page 6-6) and the throughput to the
spray nozzle (2).
To release a tube:
1. Push the blue collar of the push-in fitting down (A).
2. Pull the tube out of the fitting (B).
Figure 44. Disconnect the filter tubes
2. Examine the flow direction of the filter (arrow).
3. Hold the tube-filter assembly under a water tap. Let water flow through the tube-filter assembly
against the flow direction. If necessary, use warm water and a non-aggressive cleaning detergent.
4. Connect the tubes of the tube-filter assembly to the pump (1) and the throughput to the spray nozzle
(2). Make sure the flow direction is correct (to the spray nozzle).
Close-up
1. Install the upper cover (see Remove or install the Covers on page 5-2).
2. Drive the Machine to the Charging Station (see page 5-6).
3. Start the time path (see Start or Stop the Time Path on page 5-32).
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...
Need help?
General
