LELY Shuttle - Examine the Spoon; Examine if the Float Chamber Contains the Correct Volume

5.1501.8502.0 A
6-6 Maintenance
6.2.3 Examine the Spoon
Figure 33. Spoon assembly
KEY: 1. Screw - 2. Roller - 3. Spoon assembly
1. Examine if the roller (2) in the spoon turret can
turn freely. If necessary, replace the roller (2)
(see figure 33 on page 6-6).
Figure 34. Spoon assembly
KEY: 1. Swivel - 2. Seal - 3. Float chamber - 4. Valve - 5. O-
ring (2x) - 6. Tube connection piece - 7. Tube - 8. Roller
2. Examine if the seal (2) and two o-rings (5) in the
spoon, are in a good condition (i.e. they shown no
signs of leakage). If necessary, replace a worn or
damaged seal and/or o-ring(s) (see figure 34 on
page 6-6).
1. Remove the float chamber (3) from the
Swivel (1).
2. Examine the seal (2) and the two o-rings (5).
If necessary, replace the worn or damaged
seal or o-ring(s).
3. Install and hand-tighten the float chamber (3)
to the Swivel (1).
6.2.4 Examine if the Float Chamber Contains the Correct Volume
1. Remove the spoon assembly from the Shuttle and hang it on a hook.
in n o vato rs in agriculture