7.Positionthedriveadapterandthe2.5-inchdriveintothe3.5-inchdrivebracket.Alignthescrewholesin
thedriveadapterandthe2.5-inchdrivewiththecorrespondingholesinthebracket.Then,installthe
fivescrewstosecurethedriveadapterandthe2.5-inchdriveintothebracket.
Figure119.Installingthescrewstosecurethedriveadapterandthe2.5-inchdrivetothebracket
8.Slidethe2.5-inchdriveintothedrivebayfromthefrontuntilitsnapsintoposition,andthencompletely
closethehandle.
Figure120.Installingthe2.5-inchdrive
9.Checkthehot-swap-drivestatusLEDstoensurethatthe2.5-inchdriveisoperatingcorrectly.Youmight
havetorestarttheserverforthenewlyinstalled2.5-inchdrivetoberecognized.See“Hot-swap-drive
LEDs”onpage30.Ifthe2.5-inchdriveisfaulty,reinstallorreplaceituntilitisoperatingcorrectly.
10.Closethefrontdoor(ifavailable).
Chapter6.Replacinghardware153
To Next Page
Loading...
