Lenovo ThinkServer TD350 - Page 189

2.Iftheserverisinstalledinarackcabinet,removetheserverfromtherackcabinetandplaceitonaflat,
clean,andstatic-protectivesurface.SeetheRackInstallationInstructionsthatcomeswiththeserver.If
theserverisintowerformfactor,laytheserveronitssideforeasieroperation.
3.Removetheservercover.See“Removingtheservercover”onpage72.
4.Removethecoolingshroud.See“Removingthecoolingshroud”onpage75.
5.Recordthecomponentlocations,cableconnections,andcableroutingintheserver.
6.Removeallmemorymodules.See“Removingamemorymodule”onpage89.
7.RemoveallPCIecards,includingtheEthernetcardandRAIDcard.See“RemovingaPCIecard”
onpage93.
8.RemovetheTPMifoneisinstalled.See“RemovingtheTPM”onpage112.
9.RemovetheTSMPremiummoduleifoneisinstalled.See“RemovingtheTSMPremiummodule”on
page108.
10.RemovetheSDmoduleifoneisinstalled.See“InstallingorremovingtheSDmodule”onpage95.
11.Removethecoin-cellbattery.See“Replacingthecoin-cellbattery”onpage172.
12.Removetheheatsinks.See“Replacingtheheatsink”onpage169.
13.RemovethePCIecardholders.See“RemovingandreinstallingthePCIecardholder”onpage80.
14.Removeanyinstalledsystemfanthatimpedesyouraccesstocablesandthendisconnectallcables
fromthesystemboard.
15.Loosenthetwoscrewsthatsecurethesystemboard.Gentlylifteachedgeofthesystemboardslightly
upwardsothatthesystemboardisdisengagedfromthemountingstubsonthechassis.Then,carefully
removethesystemboardoutofthechassis.
Note:Carefullyhandlethesystemboardbyitsedges.
Figure143.Removingthesystemboard
16.Placetheoldsystemboardonaclean,flat,andstatic-protectivesurface.Touchthestatic-protective
packagethatcontainsthenewsystemboardtoanyunpaintedsurfaceontheoutsideoftheserver.
Then,takethenewsystemboardoutofthepackage.
Chapter6.Replacinghardware175