Lenovo ThinkSystem NE1032T User Manual

58 NE1032T Installation Guide
ToinstallanSFP+opticaltransceiverinanSFP+portslotontheswitch,complete
thefollowingsteps.
Note: ToavoiddamagetothecableortheSFP+transceiver,donotconnectthe
cablebeforeyouinstallthetransceiver.
1. Removethesafetycapandpullthelockingleverintothedown(unlocked)

position.
2. Insertthetransceiverintotheslotuntilitclicksintoplace.Useminimalpressure
whenyouinsertthetransceiverintotheslot.Donotuseexcessiveforcewhenyou
insertthetransceiveroryoumightdamagethetransceiverortheslot.
Thetransceiverhasamechanicalguidekeytoprevent
youfrominsertingthe
transceiverinanincorrectorientation.
3. Pullupthelockinglevertolockthetransceiverintoplace.
4. Connectthefiber‐opticcablefollowingthe“CablingGuidelines”onpage 39.
ToremoveanSFP+opticaltransceiver,disconnectthefiber‐opticcable,andpull
downthelockinglevertorelease
the transceiver.Afteryouremovethetransceiver,
replacethesafetycap.

Lenovo ThinkSystem NE1032T Specifications

General

Brand	Lenovo
Model	ThinkSystem NE1032T
Category	Switch
Language	English