Lenovo ThinkSystem NE1032T User Manual

© Copyright Lenovo 2017 Chapter 5: Initializing the NE1032T 81
Connecting to the Switch
UsetheswitchCommand‐LineInterface(CLI)toperformadditionalconfiguration
tasks.YoucanaccesstheCLIusingtheserialconsoleportormanagementport.
Using the Serial Console Port
YoucanaccesstheswitchCLIthroughtheserialconsoleportonthefrontpanelof
theswitch.ThisportusesRS‐232serialcommunications.Usetheconsolecablekit
toconnecttheserialconsoleporttoaterminaloracomputerrunningaterminal
emulationprogram.
Theconsoleportterminal‐
emulationrequirementsareasfollows:
 Defaultbaudrate=9,600bps
 Charactersize=8characters
 Parity=none
 Stopbits=1
 Databits=8
 Flowcontrol=none
Using the Management Port
IftheswitchisconnectedtoanetworkthatemploysDHCP,youcanalsoaccessthe
switchCLIthroughtheRJ‐45managementport.ThisportusesEthernet
communicationsandcanbeaccessedusingTelnet,SNMP,oraWebbrowser via
theIPaddressprovidedbythenetwork’sDHCPserver.

Lenovo ThinkSystem NE1032T Specifications

General

Brand	Lenovo
Model	ThinkSystem NE1032T
Category	Switch
Language	English