Two-AnyBay-backplane combinations
Follow the instructions in this section to learn how do cable routing for combinations with two AnyBay
backplanes.
Note: These combinations require four installed processors.
See the following sections for cable routing combinations with two AnyBay drive backplanes.
•
“Without PCIe switch card” on page 103
– “Two backplanes” on page 103
– “Three backplanes” on page 105
– “Four backplanes” on page 108
– “Six backplanes” on page 110
• “With PCIe switch card” on page 115
– “Two backplanes” on page 116
– “Three backplanes” on page 117
– “Four backplanes” on page 119
– “Six backplanes” on page 121
Without PCIe switch card
Follow the instructions in this section to learn how do cable routing for combinations with two AnyBay
backplanes and not PCIe switch card.
Note: See
“Connecting cables to the processor and memory expansion tray” on page 50 to perform the
procedure properly while connecting PCIe cables to the processor and memory expansion tray.
Two backplanes
Two AnyBay backplanes
Chapter 3. Internal cable routing 103
To Next Page
Loading...
