Procedure
Step 1. Align the intrusion switch with the slot next to the power supply bays, and push it in.
Figure 63. Installing the intrusion switch
Step 2. Connect the cable to the system board. See
“System board connectors” on page 28 to locate the
connector on the system board.
After this task is completed
Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 282).
Demo video
Watch the procedure on YouTube
LCD diagnostics panel replacement
Follow instructions in this section to remove or install the LCD diagnostics panel.
Remove the LCD diagnostics panel
Follow instructions in this section to remove the LCD diagnostics panel.
Attention:
• Go over
“Installation Guidelines” on page 137 to ensure that you work safely.
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
“Power off the server” on page 12).
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover (see
“Remove the top cover” on page 240).
Chapter 4. Hardware replacement procedures 173
To Next Page
Loading...
