Three-AnyBay-backplane combinations
Follow the instructions in this section to learn how do cable routing for combinations with three AnyBay
backplanes.
Notes:
• These combinations require four installed processors.
• See
“Connecting cables to the processor and memory expansion tray” on page 50 to perform the
procedure properly while connecting PCIe cables to the processor and memory expansion tray.
• See
“Connecting cables to the NVMe switch cards” on page 52 to perform the procedure properly while
connecting PCIe cables to the PCIe switch cards.
See the following sections for cable routing combinations with three AnyBay drive backplanes.
• “Three backplanes” on page 126
• “Four backplanes” on page 128
• “Five backplanes” on page 130
• “Six backplanes” on page 132
Chapter 3. Internal cable routing 125
To Next Page
Loading...
