Attention:
• Go over
“Installation Guidelines” on page 137 to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Align the system board air baffle with the two pairs of guides on the sides, and lower it into the
server.
Attention: Air baffle is required for airflow that creates proper cooling. Make sure to install proper
air baffles for system configuration before the power is turned on.
Figure 121. Installing the system board air baffle
After this task is completed
Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 282).
Demo video
Watch the procedure on YouTube
System board replacement (trained technician only)
Follow instructions in this section to remove or install the system board.
About this task
Note: This task must be operated by trained technicians.
228 ThinkSystem SR860 V2 Maintenance Manual
To Next Page
Loading...
