Figure 151. Installing the 4U PCIe riser power cable assemblies
Step 4. Fasten the captive screw on the module to secure it to the expansion tray.
Notes:
• Make sure the longer (320 mm) cable is routed through the middle cable clip.
• Make sure both cable are routed through the side cable clip and the side opening as illustrated.
After this task is completed
Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 282).
Demo video
Watch the procedure on YouTube
7mm drive and drive cage replacement
Follow instructions in this section to remove or install the 7mm drive and drive cage.
Remove a 7mm drive
Follow instructions in this section to remove a 7mm drive.
About this task
Attention:
• Go over
“Installation Guidelines” on page 137 to ensure that you work safely.
Chapter 4. Hardware replacement procedures 263
To Next Page
Loading...
