Remove the front VGA assembly
Follow instructions in this section to remove the front VGA assembly.
About this task
Attention:
• Go over
“Installation Guidelines” on page 137 to ensure that you work safely.
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
“Power off the server” on page 12).
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover (see
“Remove the top cover” on page 240).
b. Remove both PCIe riser cages or fillers, the chassis air baffle, and the PCIe expansion tray (see
“Remove a 4U PCIe riser cage” on page 255, “Remove the chassis air baffle” on page 270, and
“Remove the 4U PCIe expansion tray” on page 249).
c. Remove the system board air baffle (see
“Remove the system board air baffle” on page 226) or
the processor and memory expansion tray and the expansion tray air baffle (see
“Remove the
processor and memory expansion tray” on page 219
).
d. Remove the fan cage assembly (see
“Remove the fan cage assembly” on page 153).
e. Disconnect the VGA cable from the system board.
Chapter 4. Hardware replacement procedures 161
To Next Page
Loading...
