Figure 91. Adjusting CMA
1. Press down the stop bracket and rotate it to the open position.
2. Rotate the CMA out of the way to gain access to the power supply bay.
Note: Make sure the cables are secured to the CMA with cable straps.
c. If you are installing the power supply into an empty bay, remove the power supply filler panel
from the power supply bay.
d. If more than one units are to be installed, start with the lowest available power supply bay.
Step 2. Grasp the handle on the rear of the power supply, and slide it into the power-supply bay until it
clicks into place.
Figure 92. Installing a power supply unit
Chapter 4. Hardware replacement procedures 205
To Next Page
Loading...
