Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05 121
7 Drive application
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7 Drive application
The "actuating drive speed" application provided in the 8400 BaseLine C controller is a drive solution
equipped with Lenze's experience and know-how in which function and system blocks interconnec-
ted to a signal flow clearly show the basis for implementing typical drive tasks.
The application serves to solve speed-controlled drive tasks, e.g. conveyor drives (interconnected),
extruders, test benches, vibrators, travelling drives, presses, machining tools, dosing systems.
Brief description of the features
• Pre-configured control modes for terminals and bus control (with predefined process data con-
nection to the fieldbus)
• Free configuration of input and output signals
• Offset and gain of the main setpoint (if defined via analog input)
• Up to 3 fixed setpoints for speed
• Adjustable setpoint ramp times
• Linear or S-shaped ramp
• Quick stop (QSP) with adjustable ramp time
• Connectable motor potentiometer function (as alternative setpoint source)
• Connectable process controller (PID controller) with various operating modes
• Load monitoring
Input/output interface
The application features an input interface for the connection of the signal sources (e.g. main set-
point) as well as an output interface for the control of output terminals and output ports.
Parameter
The setting/parameterisation of internal functions, the selection of setpoints and the display of ac-
tual values is executed via parameters. A re-configuration of the interfaces is also possible via the
corresponding configuration parameters.
Related topics:
Introduction: Parameterising the controller
( 12)
Commissioning with integrated keypad
( 27)
Commissioning with the »Engineer«
( 31)
To Next Page
Loading...
