Lenze 8400 BaseLine C - 11 Function Library

11 Function library
304 Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
11 Function library
This chapter describes the function and system blocks that are part of the drive application.
Function block Function
L_MPot_1
Motor potentiometer (as alternative setpoint source)
L_NSet_1
Setpoint generator
L_PCTRL_1
Process controller
L_RLQ_1
Fail-safe linking of a selected direction of rotation to the quick stop function (QSP)
System block Function
LS_AnalogInput
Interface to the analog input terminals
Analog terminals
( 111)
LS_DigitalInput
Interface to the digital input terminals
Digital terminals
( 109)
LS_DigitalOutput
Interface to the digital output terminals
Digital terminals
( 109)
LS_DisFree
Any four 16-bit signals of the application can be displayed on display codes
LS_DisFree_a
Any four analog signals of the application can be displayed on display codes
LS_DisFree_b
Any eight digital signals of the application can be displayed on a bit-coded display
code
LS_DriveInterface
Interface for drive control (DCTRL)
Device control (DCTRL)
( 44)
LS_Keypad
Keypad control
LS_ParFix
Output of different constant values
LS_ParFree_a
Output of 4 parameterisable analog signals
LS_ParFree_b
Output of 16 parameterisable digital signals
LS_SetError_1
Parameterisable responses to user-defined events are tripped